Automotive Accessories

Jeep Builder Creates Budget Rear Portal Axle by Flipping the Differential

Zeph Gage’s rear-only portal axle combines Ford 9-inch, Humvee and Jesse Haines parts for about one-fifth the cost of a typical set.

Rafael LindqvistNovember 17, 20265 min read0 views

A rear axle with geared portal hubs is shown beneath a compact off-road SUV in a workshop, with the differential mounted upside down and custom brackets and brake hardware visible.

A Jeep owner and off-road fabricator has developed a low-cost portal axle for the rear of an XJ Cherokee by turning a familiar differential design upside down. Zeph Gage’s build uses a Ford 9-inch axle housing, geared hubs from a Humvee and a set of Jesse Haines Fabrication HMMWV portal adapters. The result is a rear-only portal setup that costs roughly one-fifth of a typical aftermarket pair.

Portal axles are valued in hardcore off-roading because they place a gear stack behind each driven wheel. That arrangement lets the axle shafts sit higher and leaves less hardware hanging below the frame. Tall tires can then add further clearance. The concept is simple, but commercial portal axle sets are expensive; a typical price cited for companies such as 74Weld is about $20,000. Gage’s rear unit is estimated at about $4,000.

Reversing the driveline

The Humvee-style portal hubs use two gears, which reverses the direction of the input shaft’s rotation. To make that work with the Ford 9-inch, Gage flipped the differential upside down so the driveline turns in the correct direction. He then bolted a Yukon Gear and Axle third member to the differential. In effect, the build turns low-pinion parts into a budget high-pinion arrangement by mounting them upside down.

The setup is said to add about six inches of clearance. It also preserves full shock travel, a difficult goal with portal axles, and reduces stress on the differential. The design is described as intended to be effectively bulletproof, though that is a design expectation rather than an independently verified test result.

Why only the rear?

Installing a portal axle only at the rear may look unusual, but it is a common trick in remote-control rock crawling. Keeping the front solid axle avoids the packaging problems that can arise when fitting portal axles to a vehicle that never had them from the factory. It also avoids restricting shock travel to make room, and it keeps the ride height from becoming excessively tall. The approach is presented as a best-of-both-worlds compromise.

The project is not a bolt-on kit. Gage carried out substantial custom fabrication, including homemade brackets, custom-tapped plates and a two-piece brake rotor paired with a Ford Fusion caliper. The Fusion caliper was chosen partly because it has an integrated electric emergency brake solenoid and partly for clearance. Those details show that the low parts cost does not eliminate the need for fabrication and fitting work.

Result and limits

The finished XJ can reportedly drive over a five-gallon bucket while retaining several inches of spare clearance. That extra height at the rear is meant to keep the back end from hanging up on obstacles that the front axle can steer around. The project is framed as an ingenious, carefully considered piece of kit, and an Outdoor Auto video is cited for more detail, including how Gage matched gearing front and rear.

The build is a one-off fabrication rather than an off-the-shelf product. Its appeal lies in combining used or adapted components with a clear understanding of how portal gearing changes driveline rotation. For other builders, the main lesson is that careful packaging and parts selection can deliver portal-axle clearance at a fraction of the usual cost, provided the owner can handle custom brackets, brakes and driveline geometry.