Researchers in China have investigated how screen printing degrades copper-plated silicon heterojunction (HJT) solar cells and have proposed a modified screen design that limits the damage, in a study published in Solar Energy.
Screen printing is the standard metallization step in cell production, but in copper-plated HJT cells it is used to lay down photoresist across the full wafer area rather than to print silver paste. Corresponding author Lang Zhou explained that silver paste screens have openings covering only 2–5% of the total area, with an emulsion layer keeping the mesh away from the wafer everywhere else. Full-area photoresist coating, by contrast, typically uses a screen without emulsion coverage so that resist is deposited evenly, which means the mesh comes into direct and extensive contact with the wafer on every printing cycle.
Measured losses
Earlier investigations cited by the team found that conversion efficiency in commercial production fell from 26.2% to 25.7% over 15,000 consecutive printing cycles. The losses came mainly from open-circuit voltage and fill factor, while short-circuit current density and electrical resistance stayed largely unchanged. Minority carrier lifetime degradation rose from 0.61% with a new screen to 11.0% after 15,000 cycles.
Using three-dimensional confocal microscopy, the scientists identified progressive wear of the screen mesh knuckles as the main cause. As the knuckles flatten, their contact area with the wafer grows, placing greater mechanical stress on the passivation layers underneath. Scanning electron microscopy revealed no visible surface scratches, but photoluminescence measurements confirmed higher recombination losses, pointing to damage at the amorphous silicon/crystalline silicon interface.
Emulsion buffer layer
To stop direct mesh-to-wafer contact, the researchers added an emulsion buffer layer and evaluated six patterns with emulsion coverage ratios between 2.9% and 16.6%. Higher coverage protected the wafer better but disturbed photoresist distribution, creating a trade-off between mechanical protection and coating uniformity. A coverage ratio of 4.7% gave the best balance, holding minority carrier lifetime degradation to 0.41% after 10,000 printing cycles while keeping coating reasonably uniform.
“The findings demonstrate that a relatively simple modification to screen design can substantially mitigate printing-induced degradation, offering a practical approach to improving the manufacturing reliability of copper-plated HJT solar cells,” Zhou said.
Copper metallization momentum
The work comes as copper draws attention as a substitute for silver contacts in HJT cells. In April 2026, researchers at China's Nankai University reported a silver-free HJT cell with 25.2% efficiency, using plasma-induced interface engineering and copper electroplating to address adhesion, contact resistance and stability challenges at the ITO interface. Separately, scientists at Germany's Forschungszentrum Jülich reached 23.08% with a fully copper-metallized HJT cell, a relatively small penalty compared with its silver-metallized counterpart, while cells combining silver-copper paste on the front side with silver contacts on the rear reached 23.95%. Those results underline copper's potential to reduce silver consumption, although further improvements in processing and electrical performance remain necessary.
